On spare parts of numerical control lathe / next makings automation

  • Time:
  • Click:116
  • source:OURLOVE CNC Machining
What show in the graph is right lathe of QT 15 CNC of gram of a campstool undertakes a spare parts go up / next glassware are transformed and realize axis of prejudicial main shaft kind go up automatically / the circumstance of next makings. These 40 inches of long spare parts libraries (black, coping belt tilts bracket) the axis that can accommodate 50 to wait for turning kind. By a conveyer belt (left forehead) good treatment part conveys in workpiece basket. If you are in those who consider pair of CNC lathe to go up all the time / the labor cost that next makings have automation reduces certain handling time to compare long work thereby, so you should consider possibly by Toellner system limited company (be located in Weisikangxin city of city Wisconsin Rapids) on the spare parts that is this kind of machine tool technically to make / next glassware. Of the glassware on this kind of spare parts on makings time is moved than the hand on makings fast 30~50% , thereby the circumstance that lathe can attend to in nobody leaves long-term operation, and can will more unified production and more accurate attemper union is an organic whole. Can the machine tool that to manufactory of all or most large machine tool the home manufactures transforms this to plant on / next glassware. This manufacturer says, they compare dragon door or the robot wants petty gain much, and can be in commonly 12 or call in in the time that is less than 12 months cost. What show in the graph is so that operator hand is moved,go up from the lay out on CNC lathe of makings on / next makings are unit. Dimension of spare parts of Toellner company basis and appearance, fixed position, retroflexion the need of the spare parts, prevent spare parts turn to fold, even the element such as the length of unmanned guard run time gives lathe of client demand CNC every client the glassware on special production spare parts. Special requirement of the client can pass needle correspondence to use circumstance form a complete set all sorts of system options and satisfy further. But, the glassware on every spare parts is to use standard, modular the spare parts assembles, it can reduce cost not only, make a client OK at the same time be aimed at the following workpiece and this unit is revised inside the company. Glassware installs the place that in front of the machine tool operator stands commonly on. The floor support that uses to go to the lavatory lets go up glassware from the lay out on the machine tool, machine cycle weak point, hand to move the work of feed with the change is installed and be being accommodated. Simple to needing the part that will machined not just discharge arrives carry the applied circumstance that fight or carries a storehouse, can offer spare parts capture implement. The spare parts slips from inclined chamfer below, cut from mother capable person when the spare parts after falling, this are inclined groove breaks up in upgrade of cutting tool below. Minor part is outputted from lathe fixed in the carriage on machine tool door is fought or carrying a storehouse. To larger part and the brittle spare parts because of with other part contact generation gap or crackle, can use a spare parts to output transport. Output transport still can be used at conveying the spare parts to be operated downstream. These photographs were revealed on / the diversity of next makings systems. Install upper shaft with 15 degrees of horn kind wool blank, good prejudicial car axis kind take from the bedspring chuck of the machine tool. Like the glassware on the spare parts, spare parts capture implement use easily fixed position, blame has a spare parts to assemble only, should want to will go up thereby / next makings systems suit another a little bit is not so similar work when, whole system can be maintained simply inside the factory and revise. CNC Milling